b'Hard Maple H ardwoodI ndustrIes , I nc .www.hardwoodind.comCABINET PRIME (CAB P) SKU: 44CPEMCabinet Prime is ideal for making cabinet doors and drawer fronts.Considered the high end of mid-grade lumber yielding 66-2/3% to 83-1/3% clear face cuttings with a minimum cutting size of 3" x 3\' or 4" x 2\'.Ideal for mid length clear 2 face, and sap 2 face cuttings that require a very high percentage of sapwood on both the face and the back of the board. Cabinet Prime grades NHLA #1C after H/M surfacing.The following specs improve or clarify H.I. brand vs. NHLA standards: Sap:Grade Face: 100% sap face after straight-line rip.Splits: Maximum split allowed on each end is equal to Back Face: 100% sap face after straight-line rip.the square footage of the board in inches. Dimensions: Width 4" and wider, Length 4\' to 16\'.Sticker stain: Not allowed on either face. Minimum Yield: 66-2/3% on both faces.Black streak: Not allowed on the best face.Maximum Surfacing: 80% or better clean at H/M on both faces. 1 black streak/sm on the back face. Manufacturing: Not more than 1/2" of bow, side- Color: Uniform within the cuttings.Material frombend, wave, or twist in 8\' of length.specific regions and mills. Trim backs: No specification.Front BackGRADE CERwwwTIFIED.hardwToodind.comALLY GUARANTEED GRADE CERwwwTIFIED.hardwToodind.comALLY GUARANTEED GRADE CERwwwTIFIED.hardwToodind.comALLY GUARANTEED GRADE CERwwwTIFIED.hardwToodind.comALLY GUARANTEED GRADE CERwwwTIFIED.hardwToodind.comALLY GUARANTEED GRADE CERwwwTIFIED.hardwToodind.comALLY GUARANTEED GRADE CERwwwTIFIED.hardwToodind.comALLY GUARANTEED6.5 MAPLE 3.8 MAPLE 5.1 MAPLE 4.1 MAPLE 3.5 MAPLE 4.5 MAPLE 4.1 MAPLEH ardwoodI ndustrIes , I nc . www.hardwoodind.com'