Page 1 Page 2 Page 3 Page 4 Page 5 Page 6 Page 7 Page 8 Page 9 Page 10 Page 11 Page 12 Page 13 Page 14 Page 15 Page 16 Page 17 Page 18 Page 19 Page 20 Page 21 Page 22 Page 23 Page 24Hard Maple Hardwood Industries, Inc. hardwoodind.com Hardwood Industries, Inc. www.hardwoodind.com Front Back Cabinet Prime grades NHLA #1C after H/M surfacing. The following specs improve or clarify H.I. brand vs. NHLA standards: Cabinet Prime is ideal for making cabinet doors and drawer fronts. Considered the high end of mid-grade lumber yielding 66-2/3% to 83-1/3% clear face cuttings with a minimum cutting size of 3" x 3' or 4" x 2'. Ideal for mid length clear 2 face, and sap 2 face cuttings that require a very high percentage of sapwood on both the face and the back of the board. Cabinet Prime (CAB P)) SKU: 44CPEM • Sap: Grade Face: 100% sap face after straight-line rip. Back Face: 100% sap face after straight-line rip. • Dimensions: Width 4" and wider, Length 4' to 16'. • Minimum Yield: 66-2/3% on both faces. • Surfacing: 80% or better clean at H/M on both faces. • Manufacturing: Not more than 1/2" of bow, side- bend, wave, or twist in 8' of length. • Splits: Maximum split allowed on each end is equal to the square footage of the board in inches. • Sticker stain: Not allowed on either face. • Black streak: Not allowed on the best face. Maximum 1 black streak/sm on the back face. • Color: Uniform within the cuttings. Material from specific regions and mills. • Trim backs: No specification.