Page 1 Page 2 Page 3 Page 4 Page 5 Page 6 Page 7 Page 8 Page 9 Page 10 Page 11 Page 12 Page 13 Page 14 Page 15 Page 16 Page 17 Page 18 Page 19 Page 20 Page 21 Page 22 Page 23 Page 24Hard Maple Hardwood Industries, Inc. hardwoodind.com Hardwood Industries, Inc. www.hardwoodind.com Front Back Superior Plus W((SUP +W)) Superior Plus W grades NHLA S/B after H/M surfacing. The following specs improve or clarify H.I. brand vs. NHLA standards: Superior Plus W is similar to Superior Plus with the exception of isolating 8" and wider boards with a minimum big-cut. Ideal for single rip, long, clear 2 face and clear 1 face sap applications where that extra wide rip is required. SKU: 44S+EMW(L) Board Length Minimum Big-Cut* 7-8 ft. 7-1/4" x 84" 9-10 ft. 7-1/4" x 100" 11-12 ft. 7-1/4" x 120" 13-14 ft. 7-1/4" x 140" 15-16 ft. 7-1/4" x 160" *Denotes clear sap 1 face cut. • Sap: Grade Face: 100% sap face after straight-line rip. Back Face: 50% or better sap face after straight-line rip. • Dimensions: Widths 8" and wider, Lengths 7' to 16'. • Minimum Yield: 83-1/3% on the best face, 66-2/3% on the back face. • One big cut required in each board, as shown in the table to the right. • Size of the cut varies by length of the board. • Manufacturing: Not more than 1/2" of bow, side-bend, wave, or twist in 8' of length. • Splits: Maximum split allowed on each end is equal to the square footage of the board in inches. • Sticker stain: Not allowed on best face. Treated as a defect on the back. • Black Streak: Maximum 1 black streak/sm of the piece on best face, no restriction on back face. • Color: Material from specific regions and mills. • Trim backs: Up to 25% maximum.